Doble M5400 Sweep Frequency Response Analyzer
No stress rentals! We help you to choose the equipment that you need, we expedite shipment, and follow up.
Application
- The Doble M5400 is used to detect mechanical failure or movement of windings due to short circuits, mechanical stresses or transportation.
Key Features
- Does frequency response measurements from 10 Hz to 25 MHz
- Measures frequency response at logarithmically spaced intervals of 1.2%
- Dynamic range of measurements is 80 dB with a ±1 dB accuracy
- Highest combination of dynamic range and accuracy available
- Simple, robust test leads that meet IEC standards
| Channels | 1 |
|---|---|
| Frequency range | 10 Hz to 25 MHz |
| Output voltage | 20 V peak-to-peak at 50 Ω |
| Output protection | Short circuit protected |
| Source impedance | 50 Ω |
| Channels | 2 |
|---|---|
| Sampling | Simultaneous |
| Frequency range | 10 Hz to 25 MHz |
| Max. sampling rate | 10 MS/s |
| Input impedance | 50 Ω |
| Test method | Sweep frequency |
|---|---|
| PC Comm | Ethernet USB/Serial |
| Frequency range | 10 Hz to 25 MHz |
| Number of points | 1000 points (Default) Up to 1800 points (Extended Range) |
| Point spacing | 1.2% Logarithmic |
| Dynamic range | > 90 dB |
| Repeatability | ±1 dB to -80 dB |
| IF bandwidth | < 10% of active frequency |
| Scaling | Linear/Log |
|---|---|
| Frequency range | 10 Hz to 25 MHz, user defined within frequency range |
| Plotting | Frequency vs. Magnitude/Phase |
| Analysis | Difference, sub-band cross-correlation |
| Dimensions | 18.2 x 13.4 x 6.7 inch 46.2 x 34.0 x 17.0 cm |
|---|---|
| Weight | 13.1 lbs (6.0 kg) |
| Power supply | 100 to 240 VAC |
| Temperature | 0° to 50°C operating -25° to 70°C storage |
| Relative humidity | 0% to 95% non condensing |
| Test Leads construction | Integrated three lead system in single cable set Standard (362 kV and below): 60 ft/ 18 m Optional (> 362 kV): 100 ft/ 30 m |