HP 11850D 3 Way Power Splitter
75O, frequency range DC-2GHz.

HP 35676A 50O Trans/Refl Test Kit
Used with HP 3577A, provide measurement for 5Hz-200MHz range.

HP 35677A S-Parameter Test Set
50O test for HP 3577A System. Frequency range: 100kHz to 200MHz; directivity: >40dB

HP 35677B S-Parameter Test Set
75O test set for 3577A System. Frequency range: 100kHz to 200MHz; directivity: >40dB

HP 3577B Network Analyzer
Bandwidth: 5Hz to 200MHz. Range: 100dB. Accuracy: 0.02dB. Sensitivity: 130dBm.

HP 4195A Network/Spectrum/Impedance Analyzer
Frequency range: 20Hz to 500MHz. Freq. resolution; 0.001Hz. color graphics, graphics analysis and direct copy capability.

HP 41951A Impedance Test Kit
Can be used for impedance measurements from 100kHz to 500 MHz.

HP 4396A Network/Spectrum Analyzer
Freq. range: (Network) 100kHz - 1.8GHz: (Spectrum) 2Hz - 1.8GHz; Resolution: (Network) 1MHz; (Spectrum) 1Hz - 3MHz; Power range: (Network) -60 to +20dBm; Spectrum amplitude range: to +30dBm.

HP 85032B 50O Type N Calibration Kit
Contains precision 50O type N standards. Used to calibrate the HP 8753A and it’s 50O test sets for measurement of devices with 50O type N connectors phase matched 7mm to type N adapters are included.

HP 85033C 3.5mm Calibration Kit
Used to calibrate HP 8753A and its 50O test sets. Includes: (2) -7mm to 3.5mm male adapter; (2) -7mm to 3.5 female adapter; 3.5mm male short; 3.5mm female short; 3.5mm male open; 3.5mm female open; 3.5mm male load and 3.5mm female load.

HP 85044A 50O Trans/Refl Test Set
Freq. Range 300kHz-3GHz, max. operating level is +20dBm, RF atten. range 0-70dB (10dB steps), DC bias connectors 50O BNC (F), test port connector precision 7mm. Requires use with HP 11851B Cable Kit.

HP 85046A S-Parameter Test Set
Provides the capability to measure impedance and transmission characteristics. Impedance: 50O. Frequency: 300kHz to 3GHz; Directivity: 35dB to 1.3GHz, 30dB to 3GHz. (Accessory for 8753A).

HP 85046B S-Parameter Test Set
75O S-Parameter test set, controlled from HP 8753A, includes a prog. step atten., freq. range 300kHz-2GHz, provide capability to meas. imp. and trans. char. includes S-Params. of 2 port devices in either direction with a single conn.

HP 85047A S-Parameter Test Set
Freq.: 3MHz-6GHz; single sweep or switched out to 300kHz-3GHz; 2 BNC rear panel output; directivity: 300 kHz-1.3GHz; 35dB; 1.3GHz-3GHz: 30dB; 3GHz-6GHz: 25dB. Impedance: 50O.

HP 85050B/C/D 7mm Calibration Kits
Frequency Range: 0.045 to 18GHz Opt. 010: adds beadless airlines.

HP 85051B 7mm Verification Kit
Frequency Range: 0.045 to 18GHz.

HP 85052B/C/D 3.5mm Calibration Kits
Open and short circuits plus fixed sliding termination. Included are precision 3.5mm adapters. Frequency Range: 0.045 to 26.5GHz. Opt. 010: Adds precision 15-cm beadless airline that is useful in time domain applications.

HP 8508A Vector Voltmeter
Frequency range: 100 kHz to 2GHz; maximum input: 2V peak AC (+16dBm) + 50VDC; A(REF) channel minimum: 10 mV (-47dBm) 100kHz to 300kHz, 1mV (-47dBm) 300kHz to 3MHz 300µV. 3MHz to 1HGz (-57dBm) 3MHz to 2GHz. B channel noise level: 10µV (-8dBm).

HP 8510C Network Analyzer
Frequency: 45MHz to 50GHz; measurement results can be displayed on a large color CRT on one of two independent, yet identical channels. 80dB to 100dB dynamic range. Opt. 010: Time domain analysis.

HP 8511A Frequency Converter
Frequency: 26.5GHz. With the 8511A, the 8510B/C becomes a general purpose four channel magnitude/phase receiver. 3.5mm connectors.

HP 8511B Frequency Converter
Frequency: 50GHz. With the 8511B, the 8510B/C becomes a general purpose four channel magnitude/phase receiver. 2.4mm connectors.

HP 85110A Pulsed-RF S-Parameter Test Set
Frequency range: 2 to 20GHz. Power level 0 to 3dBm. 3.5mm connector.

HP 85132B 7mm Test Port Return Cable Set
Frequency Range DC to 18GHz.

HP 8514B S-Parameter Test Set
Frequency range: 45MHz to 20GHz. Power level 0 to 5dBm. 3.5mm connector.

HP 8515A S-Parameter Test Set
Frequency: 45MHz to 26.5GHz; contains four-channel frequency converter, bias attenuators and 3.5mm test port connectors; use with 8510B or C Network Analyzer.

HP 8517A S-Parameter Test Set
Frequency range: 45MHz to 50GHz. Power level +3 to -13dBm. 2.4mm connector.

HP 8711B - Scalar Network Analyzer
Frequency Range: 300kHz - 300MHz; output power range: 0 - +16dBm; resolution: 1Hz; 100dB of system dynamic range: internal 3.5 in. disk drive (LIF/DOS).

HP 8712B - Vector Network Analyzer
Frequency Range: 300kHz - 1300MHz output power range: 0 - +16dBm; resolution: 1Hz; 100dB of sys. dynamic range; internal 3.5 in. disk drive (LIF/DOS).

HP 8713B - Scalar Network Analyzer
Frequency Range: 300kHz - 3.0 GHz; output power range: 0 - +10dBm; resolution: 1Hz, 100dB of sys. dynamic range; internal 3.5 in. disk drive (LIF/DOS).

HP 8714B - Vector Network Analyzer
Frequency Range: 300kGz - 3.0GHz; output power range: 0 - +10dBm, resolution: 1Hz, 100dB of sys. dynamic range; internal 3.5 in. disk drive (LIF/DOS).

HP 8719C Microwave Network Analyzer
Frequency range: 50MHz to 13.5GHz; frequency resolution: 100kHz. Maximum power: +10dBm. Power flatness: ±2.0dB.

HP 8720C Microwave Network Analyzer
Frequency range: 50MHz to 20GHz. Freq. resolution: 100kHz maximum power: +10dBm; power flatness: ±2.0dB. Color version of 8720 series. Option 010 Time domain analysis.

HP 8722C Network Analyzer
Freq. range: 50MHz - 40GHz; Resolution: 100kHz; Power range: -5 to -60dBm.

HP 8751A Network Analyzer
Frequency range: 5Hz to 500MHz. Frequency resolution: 1MHz. Power range: -50 to +15dBm. Power resolution: 0.1dB. Color display.

HP 8751A Gain Phase Analyzer
Freq. range: 100kHz-300MHz; Output level range: -15 to +5dBm: Resolution: 0.2dB; Freq. resolution: 1MHz.

HP 8752B Network Analyzer
Frequency range: 300kHz to 1.3GHz. Frequency solution: 1Hz. Power output: -20 to +5dBm. Power resolution: 0.1dB. Impedance: 75O. 100 dB dynamic range. Opt 003: 3GHz frequency extension.

HP 8752C Network Analyzer
Freq. range: 300kHz - 1.3GHz; Resolution: 1Hz; Output range: -20 to +5dBm.

HP 8753C Network Analyzer
Frequency range: 300 kHz to 3GHz. Integrated 1Hz resolution synthesized source. 100dB dynamic range. Color version of 8753 series. Opt 006: 6GHz frequency extension. Opt. 010: Time domain analysis.

HP 8753D - Network Analyzer
Frequency range: 30kHz - 3GHz includes built-in 85046A 50O S-Parameter test set color display and disk drive. Standard 50O unit has two 7mm test ports. Expandable frequency range to 6GHz with opt 006.

HP 8757C Scalar Network Analyzer
Measures insertion loss or gain, return loss, SWR; freq. range: 10MHz - 40GHz with coax, 110GHz with wave guide; dynamic range: 76dB. Color display. Opt. 001 4th detector input.

HP 8757D Scalar Network Analyzer
Frequency range: 10MHz to 110GHz. 76dB dynamic range (+16 to - 60dBm). Display channels: 4. Detector inputs: 3. External disk save/recall. Color display.

HP 8757E Scalar Network Analyzer
Frequency range 10 MHz to 110GHz, 76dB dynamic range (+16 to - 60dBm). 2 display channels, 2 detector inputs and a monochrome display.

Request a Quotation
Back to list of Categories